Filter
Top Products
78 Chapter 6 Contivity 600 Option Installation
302283-E Rev 00
9
Reconnect the power cord to turn the switch back on.
Opening the Contivity 600
To access the system, you must remove remove all cables, the power cord, and the
bottom metal screws and pull the chassis from the rear. You need a Phillips
screwdriver to access the system.
1
Unplug the switch’s power cord from the back of the chassis and all the signal
cables.
2
Turn the switch over to see the bottom of the box.
3
Using the Phillips screwdriver, remove the four screws that secure the bottom
to the chassis, as shown in Figure 37.