Filter
Top Products
Chapter 5 Contivity 1600 Option Installation 69
Installing Hardware Options for the Contivity VPN Switch
Removing the Contivity 1600 top cover
To install LAN or WAN cards, or to install additional memory, you must remove
the Contivity 1600’s front bezel and then the switch’s top cover.
To remove the cover you need a Phillips screwdriver.
1
Turn off the switch’s power and remove the power cord.
Figure 30 shows how to remove the power cord from the Contivity switch.
Figure 30 Removing the Contivity 1600 power cord
2
Turn each of the two screws on the front bezel a quarter turn
counter-clockwise.
3
Grip the two handles and firmly pull the bezel towards you to unsnap it from
the chassis. Do not use the part labeled with the Nortel Networks logo and the
LEDs as a handle.
Note:
You do need to turn off the Contivity switch to remove the top
cover.
100-2240VAC
2-1A
50-60Hz
Power cable
CS160009A