Filter
Top Products
76 Chapter 5 Contivity 1600 Option Installation
302283-E Rev 00
To replace a DIMM, follow these steps.
1
Turn off the switch.
2
Remove the power cord as shown in Figure 30.
3
Remove the front bezel as shown in Figure 29.
4
Remove the top cover as shown in Figure 31.
5
Press down the locking levers on both sides of the DIMM as shown in
Figure 36.
6
Pull the DIMM up to remove it from the slot.
7
Place a new DIMM in the slot, making sure to properly position the DIMM's
alignment keys. Make sure the DIMM is pressed firmly into the socket.
8
Pull up the locking levers on both sides of the DIMM, and snap the DIMM
into the socket.
9
Replace the top cover.
10
Replace the front bezel.
11
Reconnect the power cord.
12
Turn on the switch.
Memory option
The Contivity 1600 ships with 64 Mbits of memory installed. An additional 64
Mbits can be installed. To increase the memory, contact Nortel Networks
Customer Support.