Filter
Top Products
Troubleshooting> 102
(b) To remove a sheet from the central area of the
belt (2), carefully separate the sheet from the belt
surface and withdraw the sheet.
(c) To remove a sheet just entering the fuser (3),
separate the trailing edge of the sheet from the belt,
push the fuser pressure release lever (4) towards
the front and down to release the fuser’s grip on the
sheet, and withdraw the sheet through the drum
cavity area. Then allow the pressure release lever to
rise again.
NOTE
If the sheet is well advanced into the fuser (only a short length
is still visible), do not attempt to pull it back. Follow the next
step to remove it from the rear of the printer.
2
4
3
1