Filter
Top Products
Troubleshooting > 52
The platen rotates
without paper feed, or
continuous forms
instead of cut sheets
are fed.
Sheets are not loaded
to the end.
Load sheets to the end.
The printer is in the
continuous forms mode.
Eject the continuous
forms and select cut
sheet mode for the
printer.
Paper distortion.
Sheets are not loaded
to the end, or they are
not inserted straight.
Load sheets to the end.
Paper with wrinkles,
folds or other defects.
Change paper.
Paper not specified for
the printer.
Use paper types
specified for the printer.
Unable to eject. The FF/LOAD button is
pressed.
Press the PARK button.
Improper continuous forms feed.
No line feed, and no
paper feed.
Paper is off the Pin
Tractors.
Reload paper correctly.
The adjust lever
position does not match
the paper type.
Set the adjust lever to
the correct position.
Paper distortion or jam. Forms are loaded with
their left holes out of
line with the right ones.
Load forms with their
left holes in line with
the right ones.
Inadequate distance
between the left and
right Pin Tractors,
making for loose paper.
Relocate the Pin
Tractors to tighten the
paper.
Skew paper feeding. Move the paper to make
it straight.
Paper movement is
blocked.
Remove the blockage.
Paper source is too far
from the printer.
Move the paper source
nearer to the printer.
Paper not specified for
the printer.
Use paper types
specified for this
printer.
Several blank lines
appear in the printout.
Skip over perforation
spacing is selected.
Cancel the skip over
perforation spacing.
PROBLEM CAUSE ACTION