Filter
Top Products
Specifications > 62
S
PECIFICATIONS
ITEM SPECIFICATION
Model No. D21008B (ML6300FB)
Print method Impact dot matrix
Print head 24 pins, 0.2 mm (0.0079 in) diameter
Print direction Bi-directional, short-line-seeking printing
Print speed
High Speed Draft (HSD)
Letter Quality (LQ)
Utility
400cps @ 10 cpi
100 cps @ 10 cpi
300 cps @ 10 cpi
Line Feed (LF) time Approximately 65 ms per line for LF of 4.23
mm (1/6 in)
Form Feed (FF) speed Approximately 114.3 mm/s (4.5 in/s)
Paper feed control Paper feed: yes
Vertical tab: yes
Direct line feed: yes
Duplication capability Continuous forms: the original page +5
more pages (total maximum paper thickness
less than 0.36 mm)
Cut sheet: the original page +5 more pages
(total maximum paper thickness less than
0.36 mm)
Feeding direction Feed forward
Feed backward
Feeding mode Friction feed mode (front)
Pin tractor feed mode (rear)
Continuous forms tape tail
detection method
Detected when remaining paper is
approximately 24 mm long. It can, however,
print till about 6 mm from the paper bottom
(measured at the centre of the characters).
(The print accuracy of the last page cannot
be guaranteed.)
Character sets Standard ASCII
Epson (Italics/Graphics)
IBM (Set1/Set2)
Foreign
Code Page