Filter
Top Products
2.0 INSTALLATION
The PCI-DAS1200 and PCI-DAS1200/JR boards are easy to use. This quick start procedure will help you setup,
install, and test your board quickly and easily. We assume you already know how to open the PC and install expan-
sion boards. If you are unfamiliar or uncomfortable with board installation, please refer to your computer’s
documentation.
2.1 WINDOWS 95, 98 & NT
PCI products are completely plug and play. Simply follow the steps shown below to install your PCI hardware.
1.
Turn your computer off, unplug it, open it up, and insert the PCI board into any available PCI slot.
2.
Close your computer up, plug it back in, and turn it on.
3.
Windows 95, 98 will automatically detect the board as it starts up. If the board's installation file is already
on the system, it will load without user interaction. If the installation file is not detected, you will be
prompted to insert the disk containing it. The required file is on the InstaCal disk or CD you received with
your board. The appropriate file will then be automatically loaded, and the PCI board will appear in the
Device Manager under DAS Components.
2.1.1 Install the InstaCAL™ software
InstaCal is a powerful installation, calibration, and self-test program included with all boards. It is
very important that you load and run InstaCal prior to trying to use your board. To install InstaCal, insert the Insta-
Cal disk or CD into an appropriate disk drive in your computer. From the main
Start
menu (located on the lower
left of your screen) select
R
un
. At this point type the drive letter where the InstaCal disk resides followed by
:\setup
.
For example if the InstaCal floppy disk is in your “a” drive, from the RUN screen enter
a:\setup
. (omit the period.)
Alternatively, from the RUN screen, select browse, select the drive where the InstaCal disk or CD resides, then
select
setup.exe
and click
OK
. The
Add/Remove Programs
utility found in the Control Panel can also be used. Be
sure the InstaCal floppy disk or CD is in its drive and press
Install…
.
The install wizard will now launch, and you will then be prompted for additional information. Follow the instruc-
tions and, if possible, accept the defaults. If this is your first installation, we urge you to accept the defaults. It will
be easier for us to assist you in the unlikely event of trouble during your system setup and operation.
The installation routines will create all required folders/directories and unpack the various pieces of compressed
software. The default location is on your main hard drive in a directory or folder named C:\CB\).
If you have purchased the Universal Library programmers library (highly recommended with the PCI-DAS1602
series), the installation program will install all the software required to run the PCI board as well as the Universal
Library.
2.1.2 Launching InstaCal
Prior to starting InstaCal, reboot your computer so the various changes made to your startup files are active.
Use the InstaCal shortcut if you opted to install it.
From Win95, use "Start: Run", type
inscal
32 at the prompt, and click
OK
.
Alternatively, you may use Windows Explorer to find inscal.exe. It should be on your main hard drive in a directory
called C:\CB. (if C:\ is your main hard drive). To launch InstaCal, simply double-click on the file
inscal .exe
.
3