Filter
Top Products
15
1. Functions in each area
1-7. Positioner area
N Positioner [X/Y]
These are used when performing the settings below.
PinP position setting
Wipe start position setting (WIPE, SQ #5)
Camera control
Flying key position setting
POSITIONER
Z
Chroma key area
In each case, the settings take effect only when the following menu items have been selected.
The center values of the positioner are set during the time it takes for the unit to start up after its power is
turned on. Do not operate the positioner until after the switcher has started up.
O Rotary encoder [Z]
This is used to set the PinP size, flying key size or to select the chroma key area.
In each case, the settings take effect only when the following menu items have been selected.
Positioner Rotary encoder
Valid menu
X/Y Z Switch
PinP Position adjustments Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
Hold switch down to
restore initial values (X/Y,
Z).
All PinP menus
Wipe Start position
adjustments
— Hold switch down to
restore initial values (X/Y).
WIPE/WIPEPos
WIPE/SQPos
Chroma key Selected area position
adjustments
Selected area size
adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
Hold switch down to
restore initial values (X/Y,
Z).
CHR KEY/Auto
(only when Marker
item is set to On)
Flying key Position adjustments Size adjustments
(size increased by rotating
the encoder clockwise
and reduced by rotating it
counterclockwise)
Hold switch down to
restore initial values (X/Y,
Z).
KEY/FlyKEY
Camera control X:
Pan control or focus
control
Y: Tilt control or zoom
control
— Switching between pan/tilt
control and zoom/focus
control
System/CamCTL1
System/CamCTL2