Filter
Top Products
84
Setup
TAD/FAX mode
(using the built-in answering device and receiving voice
and fax calls automatically)
Setting the unit to receive voice messages and
documents and checking your greeting message
When you turn on AUTO ANSWER (the pre-selected setting is TAD/FAX), the unit will work as a fax machine
and/or answering device.
If a fax call is detected, the unit will automatically switch to receive faxes.
If a voice call is detected, the answering device will begin recording and the caller can leave a voice message.
●
You can use a pre-recorded greeting message (p. 85) or record your own greeting message (p. 86).
Note:
●
Each incoming message recording time can be set. To change the setting, see page 102.
●
For the total recording time (including the greeting messages), see “Memory Capacity” on page 123.
●
When the remaining time is low, erase unnecessary messages from memory (p. 90, 96).
●
While an incoming call is being recorded, you can monitor it through the speaker. If this feature is not
required, set the ICM monitor feature to “OFF” (p. 103).
If the AUTO ANSWER light is off, turn it on by pressing
.
Display:
●
If the display shows “TEL/FAX MODE” or “FAX ONLY
MODE”, set the unit to “TAD/FAX MODE” (p. 67).
●
The unit will play the TAD/FAX greeting message and
the remaining time for recording incoming messages
will be displayed.
Example:
TIME = 10m13s
TAD/FAX MODE
AUTO ANSWER
1
23
4
56
7
89
0
ON
AUTO ANSWER
TAD/FAX ON