Feature/Code Selection
Setting the connecting tone
MBNM4NM1NM6N
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party’s machine.
M0N “OFF”: Deactivates this feature.
M1N “ON” (default): You will hear connecting tones.
Note:
R If the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
R The connecting tone volume cannot be adjusted.
Setting the maximum fax
speed
MBNM4NM1NM8N
M1N “14.4Kbps”
M2N “33.6Kbps” (default)
Note:
R The fax speed maybe lower than the selected speed depending on your line.
Setting auto reduction
feature
MBNM4NM3NM2N
To receive a fax document that is longer than your recording paper.
M0N “OFF”: The unit will print received documents at their original size.
M1N “ON” (default): The unit will fit received documents onto your recording
paper.
Changing the fax activation
code
MBNM4NM3NM4N
If you wish to use an extension telephone to receive faxes, activate this feature
and program the activation code.
Important:
R The fax activation code must be different from the code that you
programmed on the answering machine.
M0N “OFF”
M1N “ON” (default)
1. MMenuN A MBNM4NM3NM4N
2. Press M1N to select “ON”. A MSetN
3. Enter your code from 2 to 4 digits, using 0–9, MGN and MBN.
R The default code is “H#9”.
R Do not enter “0000”.
4. MSetN A MMenuN
Changing the silent fax
recognition ring count
MBNM4NM3NM6N
To change the number of times the unit rings while in TEL/FAX mode.
M3N “3” (default)
M4N “4”
M5N “5”
M6N “6”
M7N “7”
M8N “8”
M9N “9”
Note:
R See page 49 for details.
64
8. Programmable Features