5. Close the top cover by holding the indentations on
both sides of the unit, until locked.
11.1.2 When the recording paper is not fed
into the unit properly
The display will show the following:
– “CHECK PAPER #1 PRESS START”
1 Pull the paper input tray until it clicks into place, then
pull it completely out, lifting the front part of the tray.
Remove the recording paper and straighten.
2 Re-load the recording paper.
3 Insert the paper input tray into the unit, lifting the front
part of the tray. Then push it completely into the unit.
Note:
R If the message is still displayed, check the recording
paper specifications and load the recording paper
again. See page 14 for details.
11.1.3 When the recording paper in the
manual input tray is not fed into the unit
properly
The display will show the following.
– “CHECK PICK UP INPUT TRAY #2”
1 Remove the recording paper.
2 Re-insert the recording paper.
96
11. Paper Jams