Filter
Top Products
Basic LCD Projector Operation
Changing the input signal
Press the INPUT button
(LCD Projector) (Remote Control)
The input source for picture signals and the corresponding audio signals
can be changed by pressing the INPUT buttons on the Projector
operating panel or on the remote control. In addition, the name of the
input source selected will be displayed on the screen for approximately
5 seconds.
The signal from the source which is connected to the RGB connector is
projected.
The signal from the source which is connected to the PC-CARD IN
connector is projected.
The signal from the source which is connected to the S-VIDEO IN
connector or VIDEO IN connector is projected.
If cables are connected to both connectors, the S-VIDEO signal will be
selected automatically. (The S-VIDEO signal has priority.)
Note:
The LCD Projector is factory set so that the proper input must be selected manually with the INPUT button. For
automatic input selection according to input signal, refer to “Using Auto Input Select Feature” on page 25.
To turn off the input signal on-screen display, please see ‘Turning off the input signal display” on page 25.
If you would like to project the VIDEO signals being input to the VIDEO IN connector, do not connect any cables
to the S-VIDEO IN connector.
There is only one audio system circuit provided for the VIDEO AUDIO IN terminals for S-VIDEO and VIDEO
signals. Because of this, if using both S-VIDEO signals and VIDEO signals, it will be necessary to change over
the connectors.
The LCD Projector is shipped from the factory with the system format selection function set to “AUTO (THE
OTHERS)“. If the correct picture is not projected when VIDEO signal is input and it is necessary to change the
input to match the input signal, refer to “S-VIDEO/VIDEO Signal Format Selection” on page 17.
When RGB signal is input, please input the registered signals found on page 16.
15