Filter
Top Products
Selecting the Image Quality
This LCD Projector can select NATURAL or DYNAMIC as the special characteristic of image quality.
Follow the instructions below to select the image qualities you prefer.
The procedure and on-screen displays below are based on RGB as the input signal.
1
Press MENU to display the menu.
2
Press or to select "RGB ADJUST”, and or to display the
screen.
Note:
(1/2) or (2/2) displayed under “RGB ADJUST’ indicates that the first or
second of two setting screens is displayed.
3
Press
or to select “IMAGE QUALITY”.
Note:
You can change the setting screen by pressing
when the cursor is at
the first item on the screen. or when the cursor is at the last item on
the screen.
4
Press
or to select the image quality.
NATURAL is the factory S-VIDEO/VIDEO input signal setting.
DYNAMIC is the factory RGB or PC-CARD input signal setting.
Using the Auto Setup feature
When RGB input signal picture is projected from a PC (Personal Computer). It is possible to adjust the Vertical
position, Horizontal position, Horizontal size and Phase automatically. (This only applies for RGB input signal.)
Please follow the instructions below.
1
Input the signal of the full-screen projection image from the connected
device, and then project it.
2
Press
and
at the same time to start the Auto Setup feature.
AUTO SETUP screen is displayed.
AUTO SETUP screen disappears when Auto Setup feature is ended.
Note:
Adjusted settings are saved as is even if power is turned off.
Auto setup may not be possible if an image that is not clearly visible on
the end of the screen, or a dark image is input. In this case, refer to page
24 and adjust the image position, horizontal size, and phase.
If a signal other than the proper RGB input signal described on page 16 is
input, SIGNAL is displayed on-screen indicating that Auto Setup
is
not
possible.
23