Filter
Top Products
VIDEO/S-VIDEO Signal Format Selection
If the correct signal format is not selected and the picture does not appear as normal when VIDEO or S-VIDEO
signals are being input, select the format by the following procedure. This function is set to “AUTO (THE
OTHERS)” at the time of shipment from the factory, so that the Projector can normally be used with this setting left
as it is in the Latin America area.
1
Press MENU
to display the menu.
2
Press
or
to select VIDEO SYSTEM,
and then < or >
to display the screen.
3 Press or
to switch the setting to “AUTO (LATIN AMERICA)”,
“AUTO (THE OTHERS)”, “NTSC”, “NTSC”4.43”, “PAL”, “PAL-M”, “PAL-
N” or “SECAM” until a normal picture is obtained.
AUTO (LATIN AMERICA)
AUTO (THE OTHERS)
NTSC
NTSC4.43
PAL-M
PAL
PAL-N
SECAM
“NTSC”, “PAL-M”, or “PAL-N” is selected automatically.
“NTSC”, “NTSC4.43”, “PAL” or “SECAM” is selected automatically.
3.58
15.63
60.00
4.43
3.58
4.43
15.75
50.00
3.58
4.25 or 4.41
Note:
If using a signal source with poor picture quality, such as a dubbed tape, it may not be possible to get the picture
to display properly.
NTSC and PAL-M have the same scanning frequencies and color sub-carrier frequencies, but they have different
color modulation methods. Because of this, if the incorrect setting is selected, color pictures may appear in black-
and-white.
The video system screen is not displayed with no S-VIDEO/VIDEO input signal.
Press MENU to remove the setup screen and menu.
Horizontal scanning frequency
Vertical scanning frequency
Color sub-carrier frequency
(kHz)
(Hz)
(MHz)
17