Filter
Top Products
Product Information
Remote Control
[ Front ]
POWER Button
See page 9.
INPUT Button
See page 15.
Adjust
Buttons
See
pages 14,
19,23.
MENU Button
See page 13.
LIGHT Button
See below.
Click 2 Button
See page 30.
FREEZE Button
See page 19.
SHUTTER Button
See
page 18.
MODE Button
See page 20.
MUTE Button
See
page 18.
VOLUME +/-
Buttons
See pages 18, 31,
32,34,35.
LASER Button
See below.
Mouse Button
See page 30.
[ Side ]
Transmitter
Click 1 Button
See page 30.
Battery
compartment
Before using the Remote Control
Load the 2 “AA” batteries in the Remote Control
1
Slide the lid in the direction of the arrow.
2
Install 2 “AA” batteries as indicated inside the Battery Compartment.
3
Replace the lid and snap into place.
Battery replacement caution
•
Do not mix old and new batteries.
(Also never mix alkaline with manganese batteries.)
• Remote Control Operating Range
When using the remote control, point it at the front or rear of the LCD Projector or at the projection screen. The
range for optimum operation is within 30 degrees of the receiver at a maximum distance of about 23 feet (7m).
• Remote Control Light Up
Press the LIGHT Button to illuminate the function buttons on the remote control for 10 seconds. The light goes out
while any button is pressed down, and then comes back on for an additional 10 seconds when the button is
released.
Using the Laser Pointer on the Remote Control
When the Laser beam is aimed at the screen, the Pointer is displayed on the screen.
Laser Pointer
Press LASER
on the remote
control to activate Laser.
DO NOT look into the laser transmitter, or
arm the Laser beam at a person.
Shining
the Laser beam into the eyes could result
in eye damage
7
Warning