Filter
Top Products
28
S-VIDEO/VIDEO Signal Format Selection
If the correct signal format is not selected and the picture does not appear normal when VIDEO or S-VIDEO signal is
being input, select the format by the following procedure. This function is set to “AUTO” at the time of shipment from the
factory, so that the Projector can normally be used with this setting.
• Press MENU to remove the setup screen and menu.
• If using a signal source with poor picture quality, such as a dubbed tape, it may not be possible to get the picture to
display properly.
• NTSC and PAL-M have the same scanning frequencies and color sub-carrier frequencies, but they have different
color modulation methods. Because of this, if the incorrect setting is selected, color pictures may appear in black-
and-white.
• Setting procedure
t
e
c
r
p
e
e
a
l
t
c
e
n
s
S
E
E
:
:
:
R
E
U
T
N
N
E
E
M
m
e
n
t
o
s
i
y
n
e
t
e
S
o
g
a
r
i
a
m
u
o
t
u
r
t
e
c
g
o
c
d
n
n
f
i
i
u
a
n
P
V
F
L
I
t
e
c
p
e
a
l
c
e
s
S
E
:
:
U
N
E
M
3
4
.
4
M
N
M
O
C
C
-
-
A
T
S
S
L
L
L
C
U
T
T
A
A
A
E
A
N
N
P
P
P
S
1 Press MENU to display the menu.
2 Press or to select “Video System”, and then ENTER
to display the screen.
3 Press or to switch the setting to “AUTO”, “NTSC”,
“NTSC4.43”, “PAL”, “PAL-M”, “PAL-N” or “SECAM” until a
normal picture is obtained.
Signals that can be Input
Note