Filter
Top Products
Attaching the lens
32 - ENGLISH
Getting Started
Attaching the lens hood strap
In order to prevent the lens hood from falling off, use the supplied strap to tie the projector and the lens hood.
1) Turn the lens hood counterclockwise
to remove.
2) Remove the screw C.
Lens hood
3) Thread the lens hood strap through
the hole of the lens hood.
/HQVKRRGVWUDS 7KUHDGWKHVWUDSKHUH
$GMXVWLQJWKHSRVLWLRQRIWKHPHWDOSDUWRIWKHOHQVKRRGVWUDS
KHUHSXOOWKHOHQVKRRGVWUDSWRIL[
4) Align the screw hole with the lens
hood strap and tighten the screw that
was removed in Step 2) over the strap.
Lens hood strap
CAUTION
Do not pull the lens hood
strap forcibly.
Doing so may deform this
metal part and fail to attach
the lens hood.
5) Turn the lens hood clockwise to attach.
■
z
Aligning the point position of the lens hood
with the end (on the left) of the caution label
attached to the projector body, turn the lens
hood while pushing it until it clicks to overlap
with the point position of the projector body.
Caution label
Point position of the projector
body
Make sure to align the point
position of the lens hood
CAUTION
Put the lens hood strap
between the lens hood and the
projector body to attach the
lens hood.
Pull out the lens hood strap
outside of the lens hood.