Filter
Top Products
About indicator status
ENGLISH - 91
Maintenance
■■
When there is a problem with the lamp
The status of the indicator is displayed with the following symbols.
s
: Off,
●
: On,
H
: Flashing,
■
: On or Flashing
Indicator
Status of the projector
<POWER>
Green
<STANDBY>
Red
<WARNING
TEMP.>
Red
<WARNING
FILTER>
Orange
<SHUTTER>
Blue
<LAMP 1
REPLACE>/
<LAMP 2
REPLACE>
Orange
■
*1
■
*1
■
*1
■
*1
■
*1
H
*2
Either or both of the lamps do not turn on. (If both
of the lamps fail, they are cooling down. After the
standby indicator <STANDBY> turns on again, press
the power <POWER ON> button on the remote control
or the power button on the control panel.)
■
*1
■
*1
■
*1
■
*1
■
*1
●
The recommended time to replace the lamp has been
reached.
The
will be displayed at the top right of the screen
to notify the user of replacement.
Replace the lamp unit as soon as possible. Replacing
the lamp will cause the lamp indicator <LAMP 1
REPLACE>/<LAMP 2 REPLACE> to turn off.
*1: The indicator will turn on or ash under certain conditions, regardless of the status of other indicators.
*2: The indicator will ash in approximately 1-second intervals.
Note
■
z
The status of each lamp can be checked as the lamp indicators <LAMP 1 REPLACE>/<LAMP 2 REPLACE>
on the front of the projector turn on or ash. (
page 96)
■■
When there is a problem with the shutter
The status of the indicator is displayed with the following symbols.
s
: Off,
●
: On,
H
: Flashing,
■
: On or Flashing
Indicator
Status of the projector
<POWER>
Green
<STANDBY>
Red
<WARNING
TEMP.>
Red
<WARNING
FILTER>
Orange
<SHUTTER>
Blue
<LAMP 1
REPLACE>/
<LAMP 2
REPLACE>
Orange
■
*1
■
*1
■
*1
■
*1
H
*2
■
*1
The shutter cannot be opened or closed. The lamp will
turn off, cooling will begin and the projector will switch
to the standby mode. The power will turn on and the
projector will attempt to open the shutter automatically
up to three times. After three failed attempts, the
projector will switch to the standby mode after the
lamp has cooled.
s H
*3
s s H
*2
■
*1
There is a problem with opening or closing the shutter,
and the lamp has turned off and is cooling down.
s ● s ■
*1
H
*2
■
*1
There is a problem with opening or closing the shutter,
and projector will switch to the standby mode after the
lamp has turned off and cooled down.
*1: The indicator will turn on or ash under certain conditions, regardless of the status of other indicators.
*2: The indicator will ash in approximately 0.5-second intervals.
*3: The indicator will ash in approximately 1-second intervals.
Note
■
z
The status of each lamp can be checked as the lamp indicators <LAMP 1 REPLACE>/<LAMP 2 REPLACE>
on the front of the projector turn on or ash. (
page 96)