Paradyne 392xPLUS Network Card User Manual


 
DCP Configuration
4-673920-A2-GN31-30 November 1996
Table 4-14
(2 of 3)
Miscellaneous Configuration Options — Singleport Mode A
Access frm Remt: Enable
Nxt Enable Disable
Access from Remote. Determines if your modem’s DCP can be accessed by a remote modem via the VF line.
CAUTION: If this configuration option is disabled, the modem cannot be accessed by another modem.
Enable – Allows access from a remote modem.
Disable – Does not allow access from a remote modem.
NOTE: The remote modem must be a Model 3920
Plus
or Model 3921
Plus
modem.
The AT command is S-Register S55=
n
, where
n
is 0 for Enable and 1 for Disable.
RemAccssPasswrd: 00000000
Nxt "
00000000
Remote Access Password. Allows the entry of a password for establishing control of a remote modem from the DCP of
a local modem. The same password must be used in both the local and remote modem.
CAUTION: A remote access password should be selected for security purposes.
NOTE: If the Access from Remote configuration option is set to Disable, the password has no effect.
The AT command equivalent is S-Registers S56=
n
, S57=
x
, S58=
y
, and S59=
z
, where
n
is the leftmost pair of digits,
x
is
the second pair of digits,
y
is the third pair of digits, and
z
is the rightmost pair (or fourth) pair of digits. For example, if
the remote access password is 12345678, then the value for S56 is 1 and 2, and the value for S59 is 7 and 8.
Dir#1_Callback: Disable
Nxt Disable Enable
Directory Location 1 Callback. This configuration option controls whether or not the modem’s single number callback
function is used.
Disable – Modem does not use the single number callback function.
Enable – Modem answers a call, disconnects, and dials the number stored in directory location 1.
NOTE: This function is disabled if dial access security is enabled.
The AT Command to Disable is S-Register S67=0.
The AT Command to Enable is S-Register S67=1.
NMS_Call_Msgs: CallCnct&Prg
Nxt CallCnct&Prg Disable CallCnctOnly CallProgOnly
NMS Call Messages. Determines if the modem status and/or call summary information is sent to the NMS. The modem
can itemize status, such as CallProgress messages, or it can report a summary of activity, such as Call Connect
messages, to the NMS.
Call Connect & Progress – Enables both Call Connect and Call Progress information to be transmitted to the NMS.
Disable – Modem status and call summary information is not sent to the NMS.
Call Connect Only – The modem accumulates call statistics over a period of time and then transmits a summary of
these statistics to the NMS. The NMS uses this data to produce utilization reports.
Call Progress Only – The modem transmits detailed modem status information to the NMS. These messages include
any events that can display on the LCD.
NOTE: For 6800 Series NMS applications, Disable must be selected.
The AT commands are S-Register S66=
n
where
n
is 0 for Call Connect & Progress, 1 for Disable, 2 for Call Connect
Only, and 3 for Call Progress Only.
Modem – Selects the Diagnostic Channel.
NMS – Selects the Control Channel.
Disable – Prevents messages being sent from the diagnostic port.