Filter
Top Products
COMSPHERE 392xPlus Modems
5-14 November 1996 3920-A2-GN31-30
Table 5-2
(9 of 9)
392x
Plus
AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
\N
n
Error Control Mode.
\N0 Buffer Mode.
\N1 Direct Mode.
\N2 MNP or Disconnect.
\N3 MNP or Buffer.
\N4 V.42/MNP or Disconnect.
\N5 V.42/MNP or Buffer.
\N6 LAPM or Disconnect.
\N7 LAPM or Buffer.
Configure\Edit\
V42/MNP/Buffer
\Q
n
Flow Control of DTE, Flow Control of Modem.
Flow Control Flow Control
of DTE:
of Modem:
\Q0 Disable Disable
\Q1 XON/XOFF XON/XOFF
\Q2 CTS to DTE Disable
\Q3 CTS to DTE R
TS to Mdm
\Q4 XON/XOFF Disable
\Q5 Disable XON/XOFF
\Q6 Disable R
TS to Mdm
Configure\Edit\
V42/MNP/Buffer
\T
n
No Data Disconnect Timer.
\T0 Disable.
\Tn Where
n
is a value from 1 to 255 in 1-minute increments.
Configure\Edit\
Line Dialer
NOTE: The factory default value is country dependent.
\X
n
XON/XOFF Passthrough Flow Control.
\X0 Disable.
\X1 Enable.
Configure\Edit\
V42/MNP/Buffer
%A
n
Error Control Fallback Character.
%An Where
n
is an ASCII value from 0 to 127. Factory default is 013
ASCII.
Configure\Edit\
V42/MNP/Buffer
%C
n
MNP5 Data Compression.
%C0 Disable.
%C1 Enable.
Configure\Edit\
V42/MNP/Buffer
IH
n
V.42bis Compression.
IH0 Disable.
IH1 Enable (Transmit (TX) only).
IH2 Enable (Receive (RX) only).
IH3 Enable (Transmit (TX) and Receive (RX)).
Configure\Edit\
V42/MNP/Buffer