Filter
Top Products
DCP Operation
3-313920-A2-GN31-30 November 1996
F1
Leased:28.8
PList Control
F2
F3
Press the key until PList appears. Select PList.
Within a network link, a control modem can communicate with a tributary modem by using the
tributary modem’s network management address for polling functions. Each TMp tributary modem
must have a different network management address. Refer to the Misc section in Chapter 4 for a
description of the network management address (NetMngmtAddress) configuration option.
Over a diagnostic channel a tributary modem can communicate with control modems by using the
control modem’s network management address for polling.
In the poll list, modems are listed as either Active or Skip. Downstream modems in the Active poll
list are polled by the modem. Modems in the Skip poll list are passed over during the polling
process, but not deleted from the poll list.
Display
Display allows you to view the modem’
s poll list.
To access Display from the PList branch, make the following selection:
F1
Poll List: >
Display Clear
F2
F3
Select
Display
.
NOTE
If there are no modems in the poll list when you select Display, the
message Poll List Empty! appears on the second line of the LCD.
F1
Poll List:Disp
Nxt xxx yyyyyy
F2
F3
If
there are modems in the poll list when you select Display
,
xxx
Displays the network management address of the modem in the poll list.
yyyyyy Displays either Active or Skip to indicate the poll list in which the network
management address is included.