Filter
Top Products
DCP Operation
3-493920-A2-GN31-30 November 1996
If
unsuccessful, the modem remains in the Download T
ransfer mode. The LCD’
s top line displays
RemClone Failed
and the bottom line displays one of the following messages:
Incompat Modulat The modems are connected, but are using a modulation scheme other
than V
.34 family
, V
.33, V.32 family
, V
.29, or TMp.
No Response
The remote modem is not a 3900 Series modem or the connection
between the two modems is poor
.
Access Disabled
The remote modem’
s Access from Remote configuration is disabled.
Password Invalid
The local and remote modems’ passwords do not match. Correct the
problem and attempt another download from the local modem. If this
fails, contact your service representative.
No Cir
cuit There is no connection between the local and remote modem.
After successful establishment of a Remote Cloning Download session, the following screens
appear.
F1
RemClone Status
Initializing
F2
F3
F1
RemClone Status
Bank1:xxxx/yyyy
F2
F3
As the firmware transfers, the local and remote LCD’
s bottom line displays the status of the
download process, plus the number of records sent versus the total number of records for that data
bank number.
For Single
download applications, if the download is successful, the local modem displays
Remote Clone OK
and the remote modem displays
Frmware Upgrade. If the download took
place over the dial network, the modems disconnect when the download is complete.
If the Single
download is unsuccessful,
RemClone Failed appears on the LCD’s top line. Attempt
another download from the local modem. If this fails, contact your service representative.