Filter
Top Products
Completing the hardware installation 30
Model 2616RC T-DAC User Manual 2 • Hardware installation
Completing the hardware installation
This section verifies that the T-DAC hardware is operational to the point where you can begin configuring the
software settings.
Power is delivered from the Patton ForeFront chassis backplane through the 47-pin PICMG 2.11 power con-
nectors on the 2616RC blades. Upon insertion into the Patton ForeFront chassis, the Model 2616RC immedi-
ately powers up and begins its boot cycle. During the boot cycle the following should occur:
1. The POWER LED illuminates, indicating normal power is being applied to the 2616RC.
2. The green SYSTEM LED begins flashing, indicating the 2616RC is operating normally.
Hardware installation is now complete. To configure the 2616RC for operation, refer to chapter 3, “Configur-
ing the T-DAC for operation” on page 31.