Filter
Top Products
615 Bar code width is greater than 16 inches, or number of keywords
for PDF 417 exceeds 928. Decrease the density or shorten the
amount of data to print the bar code.
616 Dot shifting failed. A bad dot falls on a bar code that cannot be
shifted. Call Technical Support.
618
Magnification must be 1-7or 4 - 250 for the scalable font.
621 An error occurred opening the TrueType font file. Select a
different font to download. If the error message persists, call
Technical Support.
622 Not enough memory to create the downloaded TrueType
characters in the scalable (vector) fonts buffer. Reconfigure the
printer ’s memory and increase the scalable (vector) fonts buffer.
Resend the font, format, and batch packet after reconfiguring the
memory. If the error message persists, call Technical Support.
Machine Faults
These errors occur when there is a problem with the printer.
703 The printer sensed a calibration of different-sized black marks.
Make sure the correct supply is loaded.
704 Printer has not sensed a supply mark within the specified number
of inches or is out of supplies. Check the supply tracking, supply
marks, black mark sensor position, and supply roll for binding.
Change supply.
706 The motor could not get up to speed within the allotted time. Call
Technical Support.
707 The motor reached the desired speed, but was unable to maintain
that speed. Call Technical Support.
708 The motor has stalled or is running too slow to measure the
speed. Call Technical Support.
750 Printhead is overheated. Turn off the printer to let the printhead
cool. If the error persists, call Technical Support.
6-14 Troubleshooting