Filter
Top Products
SYMBOL SETS/CODE PAGES C
This appendix contains a listing of the symbol sets, code pages,
and extended character sets the printers support.
Use the charts in this appendix to convert dot sequences from the
image dot pattern to codes you can use in the fields. Use the
Binary to Hex Conversion Chart to convert Binary dot sequences to
Hexadecimal numbers for bitmap files. Use the Dot to Run Length
Encoding Chart to convert dot sequences to alphabetic characters
for bitmap files.
Supported Symbol Sets and Code Pages
The printer supports these symbol sets and code pages: Internal,
ANSI, Bold, OCRA Character Set, DOS Code Page 437 and 850.
Additional Code Pages are supported with downloaded TrueType
or Unicode (double-byte) fonts.
The printer defaults to the internal symbol set.
Note: Fonts 1004, 1005, 1010, and 1011 are limited to the following
special characters: 0123456789#$%&(),./@DFKLMPS\kprö¢£¥.
These fonts do not support the full ANSI character set and some
characters above decimal value 127 are substituted.
Selecting a Symbol Set or Code Page
The CG Triumvirate™ typefaces support only the ANSI and DOS Code Page
437 and 850 Symbol Sets. These fonts print a slashed zero when using the
ANSI symbol set.
Internal Use this symbol set to print international monetary
symbols, the trademark (™) symbol, and for formats that
maybeusedonotherMPCLIIprinters.
ANSI Use this symbol set with proportionally spaced
fonts.
DOS Code
Pages 437 or 850
Use this symbol set for extended and international
characters with proportionally spaced fonts.
Symbol Sets/Code Pages C-1