Filter
Top Products
C2907M-D (4/05) 9
Instructions for the Network Administrator
The PelcoNet NET350 transmission system allows live video transmission to be viewed over TCP/IP-based networks. This section is intended to
help the network administrator know what is involved with installing this product and how it will affect the network. The person installing the
product will need the following information about the network to make the network function properly.
THE TRANSMITTER AND RECEIVER
•A valid IP address* for each PelcoNet NET350 transmission system unit
• Subnet mask*
• Default gateway (if applicable)
• E-mail server’s IP address (if applicable)
• Dedicated maximum allowable amount of bandwidth for live video**
* = Required for the PelcoNet NET350 transmission system to function properly
** = The PelcoNet NET350 transmission system requires a continuous amount of bandwidth to display true live video. Pelco recommends
using switching hubs with the product so the amount of bandwidth available to each unit is constant and reliable.
THE BROWSER
If you plan to use a browser to view live video across the network, there are procedures to complete before you can use the browser, such as
installing the ActiveX
®
platform. If you installed Internet Explorer 6.0 from the CD that came with the PelcoNet NET350 transmission system, you
can skip step 1 below. Otherwise, perform the following before trying to use the browser.
1. Internet Explorer 6.0 or higher must be installed before continuing.
2. Set the computer’s display settings to use 16- or 32-bit color.
3. Insert the supplied resource CD. It will open automatically.
If it fails to open automatically,
perform steps a through d below.
a. Click the
Start
menu in the Windows
®
operating system.
b. Click
Run.
c. In the Open box, type
D:\START.EXE
(where D:\ = your CD ROM drive letter).
d. Click
OK.
4. Click
Software
and then click
Install PelcoNet ActiveX.
5. Follow the on-screen setup instructions to finish installing the plug-in.
MINIMUM PC REQUIREMENTS (AS NEEDED)
• PC (Pentium
®
4 microprocessor, 1.6 GHz) with Windows 98/2000/XP operating system
• Network card
• Microsoft
®
Internet Explorer 6.0 (or higher) or PelcoNet NET350R (receiver) and video monitor
• Free serial interface and terminal program
• Screen resolution of 1024 x 768 or higher, 16- or 32-bit pixel color resolution
• RAM of 256 MB
• Graphic card (ATI RADEON 7500 or 8500, Matrox G 550 or Parhelia
™
, or NVIDIA
®
GeForce 3 or 4 with direct show-compatible MPEG-4
playback capability)
• Ethernet card (100 Mbit recommended)
• Sound card (required for audio application)
• DirectX
®
8.1 or 9.0 application programming interface software