Filter
Top Products
28 C1522M-C (2/05)
CONNECTING GENEX MULTIPLEXERS
Use COM 4 to connect up to eight Genex Multiplexers to the CM6800-32X6.
1. Connect the COM IN port of the multiplexer to COM 4 on the CM6800-32X6, using the 6-foot (1.8 m) reversed data cable supplied
with the CM6800.
One reversed cable and two straight cables are supplied with the CM6800 (save the reversed cable for connecting a Genex
multiplexer, if applicable).
A straight data cable is supplied with the Genex multiplexer. Use this cable for connecting a second Genex multiplexer to the first
multiplexer, if necessary.
2. Connect the MAIN monitor output from the multiplexer to any of the camera inputs on the CM6800-32X6.
3. Connect cameras to the multiplexer and then loop them to the CM6800. Refer to the MX4000 Genex Series Simplex and Duplex
Multiplexers Installation/Operation Manual for detailed camera connection instructions. Terminate the video loop at the CM6800.
4. If required, you can connect a total of eight Genex multiplexers through COM 4. Daisy-chain the multiplexers by connecting a
straight data cable from the COM OUT port on the first multiplexer to the COM IN port on the second multiplexer; connect the COM
OUT port on the second multiplexer to the COM IN port on the third multiplexer. Continue to the eighth multiplexer, if necessary.
Refer to the
System Start-Up
section for additional configuration steps required when using a Genex Multiplexer.
Figure 22. Connecting Genex Multiplexers
COM 1
2
3
4
5
16
1514131211109
8
7654321
654
3231302928272625
24
23
22
2120191817
321
120/230V~
50/60 HZ
25 WATTS
12345678
CONTROL
T
+
T
-
R
+
R
-
HZ
75
2
VCR
AUX
MAIN
SPOT
SVHS
OUT IN
SVHS
IN COM OUT N N
H
O C C S
ALARMS
1 2 3 4 5 6 7 8 9 10 11 14 15 16 12 13
110-240V 50/60 Hz
VCR
AUX
MAIN SPOT
SVHS
OUT IN
SVHS
IN COM OUT N N
H
O C
C
S
ALARMS
1 2 3 4 5 6 7 8 9 10 11 14 15 16 12 13
110-240V 50/60 Hz
VCR
AUX
MAIN SPOT
SVHS
OUT IN
SVHS
IN COM OUT
N N
H
O C C S
ALARMS
1 2 3 4 5 6 7 8 9 10 11 14 15 16 12 13
110-240V 50/60 Hz
GENEX MULTIPLEXER
RJ-45 PIN-OUTS
Rx+
Rx-
NC
NC
GROUND
NC
Tx-
Tx+
CM6800-32X6 COM 4
RJ-45 PIN-OUTS
GENEX MULTIPLEXERS-8 MAXIMUM
GENEX MULTIPLEXER
GENEX MULTIPLEXER
GENEX MULTIPLEXER
1
2
3
4
5
6
7
8
REVERSED CABLE
MONITOR SIGNAL OUT
1
2
3
4
5
6
7
8
Rx+
Rx-
12VAC (OUT)
12VAC
GROUND
NC
Tx-
Tx+
(OUT)
STRAIGHT CABLE
STRAIGHT CABLE
010101