Filter
Top Products
76 C1528M-F (6/05)
MACRO COMMANDS
Table H provides a description of each macro command and the additional fields required for each command. Refer to the Macro section
for instructions on programming macros.
Table H. Macro Commands
Command Description Specify Field(s)
GON Activate an auxiliary. Auxiliary Command #
GOFF Turn off an auxiliary. Auxiliary Command #
Auxiliary Notes:
• “Global” includes both internal and external auxiliaries.
• Auxiliaries on the rear panel of the CM6800E Matrix Switcher are activated by global auxiliary numbers 1, 2 and 3.
CON Activate a camera auxiliary. Camera auxiliary Command #
Camera Camera
Monitor Monitor
COFF Turn off a camera auxiliary. Camera auxiliary Command #
Camera Camera
Monitor Monitor
SEQ Start a sequence. A sequence runs continuously until a system operator selects Sequence Command #
a different camera, or an event timer starts another sequence or macro.
Monitor Monitor
SWT Switch a camera to a monitor. Camera Camera
Monitor Monitor
COPY Copy a camera view to a monitor. Monitor to copy from Command #
Monitor to copy to Monitor
GO TO Go to step number specified. Step Command #
LOOP Loop a macro. 0 = loop continuously Command #
1-999 = loop the specified
number of times
?AUX Check a local auxiliary; if the auxiliary is active, the next step is executed; if Local auxiliary Command #
the auxiliary is not active, the next step is skipped.
?ALM Check an internal alarm; if the alarm is active, the next step is executed; if Alarm Command #
not, the next step is skipped.
?SW Check whether a camera is displayed on a monitor; if it is, the next step is Camera Camera
executed; if not, the next step is skipped.
Monitor Monitor
STPM Stop a macro. Macro Command #
END Exit the macro; no further steps are executed. Any macro or sequence started None None
by this macro will continue to run.
DON Displays on-screen text on the specified monitor. Monitor Monitor
DOFF Removes on-screen text from the specified monitor. Monitor Monitor
MSWT Switch a camera connected through the multiplexer. Camera to switch
◆
Command #
Multiplexer input Camera
Monitor Monitor
PIPB Display multiplexer picture-in-picture view with the Background camera
◆
Command #
designated camera in the background.
Multiplexer input Camera
Monitor Monitor
PIPF Display multiplexer picture-in-picture view with the Foreground camera
◆
Command #
designated camera in the foreground.
Multiplexer input Camera
Monitor Monitor
◆
For multiplexer functions, the camera number is the number of the video input on the multiplexer. The multiplexer input number is the number
of the video input on the rear panel of the CM6800E.
(Continued on next page)