Filter
Top Products
Setting Jumpers 213
Introduction
IOLAN RJ45
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
Power
Dip
Switch
Reset
RJ45
RJ45 Serial
Screw
Screw
J1
J9
3. To turn line termination on, locate and jumper both J1 and J9.
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
IOLAN DB9
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
Power
Dip
Switch
Reset
RJ45
DB9 Serial
Screw
Screw
J1
J9
3. To turn line termination on, locate and jumper both J1 and J9.
4. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.