Filter
Top Products
Frequently asked questions
86
Problem Solution
I get interference on my wireless
(Wi-Fi) link between and .
The WACS7500 operates in the 2.4GHz
radio frequency spectrum.Many other
household/IT devices also operate in this
frequency spectrum,for example:
microwave ovens, Dect phones, bluetooth
devices like bluetooth headphones,
computer mouses, wireless routers,
cordless phones,Wi-Fi compatible
printers, PDAs.These devices can
interfere with the Wi-Fi link between
and , resulting in interference such as
pause during playback, slow response to
my operation, etc.The severity of
interference varies depending on the
extent of radiation from the device and
the strength of Wi-Fi signals in that
position.
• If you are playing the set, stop playback and take the
appropriate measures as follows:
• Keep or at least 3 meters away from such
devices.
• Use the WEP/WPA key when connecting and
to an existing wireless PC network.To set
WEP/WPA key, connect / to your PC using
Philips Wireless Audio Device Manager (WADM) in
the supplied PC Suite CD. In the WADM device
configuration, enter the Wireless Network submenu,
and in Device Wireless Authentication Type, select
WEP or WPA.
• Change operating channel of and when
connecting them to an existing wireless PC network.
To change channels, connect / to your PC
using Philips Wireless Audio Device Manager
(WADM) in the supplied PC Suite CD. In the
WADM Device configuration, enter the SSID of your
Wireless Network, and select ad-hoc mode. See the
section
12 Connect to your PC and the WADM
help file.
• If possible, change the operating channels of the
other Wi-Fi devices in your home.
• Turn the devices in different directions to minimize
interference.
Stations react when you operate the
remote control of .
• The remote control for is powerful enough to
operate several within a certain distance or
angle. Check that you have placed in different
rooms or place them at different angles.
• Use the remote control for or the controls on
the set.
‘x’ flashes on the synchronous
display of the remote control of .
Signal error. Check that you have pointed the remote
control towards the IR sensor of the set you wish to
operate.