Filter
Top Products
17
En
Installation and Connections
English
1
2
How to route cables
Speed clamps and bead bands are included with the
plasma display for bunching cables together. Once
components are connected, follow the following steps to
route cables.
The illustration depicts the PDP-504CMX/PDP-50MXE1/
PDP-50MXE1-S with video card PDA-5003.
* As viewed from the rear of the display.
Installation and Connections
1 Organize cables together using the provided
speed clamps.
Insert 1 into an appropriate hole on the rear of the
unit, then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo
once in place. Please attach carefully.
To attach the speed clamps to the display
Connect the speed clamps using the 6 holes marked
with “‡” below, depending on the situation.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over time
and may be damaged when removed.
2 Bunch separated cables together and secure them
with the provided bead bands.
Do not allow excessive stress to be placed on the
ends of cables.
Note
Cables can be routed to the right or left.
The illustration depicts the PDP-504CMX/PDP-50MXE1/
PDP-50MXE1-S with video card PDA-5003.
* As viewed from the rear
of the display.