Filter
Top Products
21
En
Operation
English
Selecting input source
This section explains the basic operation of the plasma
display. Outlined on the following pages is how to turn
the main power on and off, put this display in the
operation or standby mode and how to select connected
components.
Before you begin, make sure you have:
•
Made connections between the plasma display and AV
components or personal computer as described in the
section “Installation and Connections” starting on page 6.
• Set up the on-screen menu to input signals from
components connected to INPUT1, INPUT2 and
INPUT5 as described in the section “System Settings”
starting on page 18.
If no connections are made to these terminals,
on-screen setup is not necessary.
VOLUME
[+/–]
INPUT
STANDBY/
ON
1 Set the rear panel MAIN POWER switch to ON.
The STANDBY indicator on the front panel will light
red.
2 Press the STANDBY/ON button to turn the power
ON.
The ON indicator on the front panel will light green.
Operation
3 Press the INPUT button on the remote control unit
or the display to select the input.
Input changes each time the display’s INPUT button is
pressed as follows:
• When the menu screen is displayed, changing the
signal input will cause the menu screen to turn off.
• If the input computer signal is not supported by the
display, the following message will be displayed:
:
588
512 684
k
HzfV .
:
78
1
6
HzfH .
X
INPUT1
FULL
CAUTION
UNSUPPORTED SIGNAL
:
020
––––
k
HzfV .
:
77
1
5
HzfH .
INPUT1
FULL
CAUTION
OUT OF RANGE
4 Use VOLUME (+/–) buttons on the remote control
unit or the display to adjust the sound volume.
If no audio connections are made to the plasma
display, this step is not necessary.
5 When viewing is finished, press the STANDBY/ON
button to put the display in standby mode.
6 Set the rear panel MAIN POWER switch to OFF.
The STANDBY indicator may continue to light for a
short while even after the main power is turned off.
This is a result of residual electric load impressed on
the circuitry, and the light will turn off presently.
Note
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
“screen burn” which leaves a ghost, or residual, image of the
picture on the screen.
Remote control unitDisplay operating
panel
3 INPUT1
INPUT5 2
3 INPUT2 3 INPUT3
INPUT4 2
VOLUME
[+/–]
INPUT
STANDBY/
ON