Filter
Top Products
2-5
Setup
Assembling
the Printer
(continued)
2. Install the Shock
A. Insert the screw through
the hole on the printer
wall and secure with the
bolt provided.
B. Snap the shock onto
the bolt as shown in the
picture at right.
C. Snap the other end of the shock onto the bolt inside the
printer cover.
Properly installed shock
D. Push in the plastic end caps to lock the shock onto each
ball attachment.
NOTE: This cap must be pulled open to remove the
shock.
SV61183 Book.indb 2-5SV61183 Book.indb 2-5 6/9/2004 9:16:41 AM6/9/2004 9:16:41 AM