Filter
Top Products
5-10
Printer Maintenance
Cleaning the
Wipers
The wipers beneath the banks of print cartridges will, over
time, pick up ink, wax, clay and other material from the
media it touches. Once enough of this material accumu-
lates on the wipers, it will leave marks or smears on the
media.
1. Loosen the Print Head Assembly locating screw.
2. Swivel the Print Head
Assembly up and back
to expose the wipers.
(You may need to
move the Print Head
Assembliy to the front or
rear to gain clearance
to swivel the assembly
fully back).
3. Use water to dampen a soft cloth to remove any ink,
wax, clay, etc. and keep the wipers clean.
Cleaning the
Transport
Belts and
Floor
Assembly
Ink will get sprayed on the transport belts and the floor
assembly from all the purging, setting up and printing
records, etc. Eventually enough ink will accumulate on the
Transport Belts to give them a glossy sheen.
Use water to dampen a soft cotton cloth to remove ink
from the Transport Belts and the Floor Assembly.
NOTE: Raise the Print
Head Assemblies up and
out of the way to clear
the Floor Assembly.
SV61183 Book.indb 5-10SV61183 Book.indb 5-10 6/9/2004 9:16:58 AM6/9/2004 9:16:58 AM