Filter
Top Products
4
Basics
Setting
Up A Job
(continued)
2. Center the Feed Ramp under the Material
A. Loosen the Wireframe
Clamp Knob.
B. Place a sample piece
of ma te ri al in the feed
area, up against the rear
wall. Center the feed
ramp under your sample
piece of material.
Be sure to set the ramp
in a postion where the
material rests on the
ramp.
SV61183 Book.indb 3-4SV61183 Book.indb 3-4 6/9/2004 9:16:47 AM6/9/2004 9:16:47 AM