Filter
Top Products
IDL series User Guide
170
Protocol
configure to build a specific protocol stack automatically. This field is
meaningful only when autostatus flag as enable. In case of conflict with
autoSupportedProtocols, its value will override.
Auto Sense Trigger
Type
This field specifies at what time autodetection of Encapsulation type or
higher protocol layers is to be done - all the time or only when Operational
Status of ATM VC is changed to UP. If its value is 'dynamic', then detection
can happen anytime a packet is received. If its value is 'opstatechange',
then autodetection happens only when Operational status of ATM VC
changes to UP. This field is not valid if encaptype is Ethernet.
Auto Curr Sensed
Encaps Type
This field specifies the current sensed Encapsulation type in case the
Encapsulation type is being autodetected. The value of this field will be the
same as the field 'AAL5 Encapsulation Type' if the Encapsulation type is
preconfigured. This is a read only field for all agents, except for the Auto
Sense Agent.
Ctl Pkts Group Id
The Control packet instance group associated with this VC. The flows for
this interface shall be mapped to control packet instances as mapped for
the flows corresponding to the groupid configured in ctrlpkt group info
command. If this group does not have entries for some of the flows, then
those flows shall be mapped to the ctlpktinstid of ATM port, for which this
VC is being created. If the group id is 0, then all the flows shall be mapped
to ctlpktinstid of ATM port, for which this VC is being created.
Caution:
The specified lower interface should exist. Please refer to the create atm port
command.
References:
z ATM interface commands
z ATM statistics commands
z ATM OAM commands
z ATM VC statistics commands.