Filter
Top Products
IP DSLAM
351
check if the value at the location specified in the packet is in the
range specified by 'Value' and 'ValEnd'. 'TerCmp' means check if
the value at the location specified in the packet is less than, equals
to or greater than the 'Value'. 'MatchInList' means take the branch
of the node whose value is equals to the value at the location
specified in the packet. 'AccDeny' means check if the value at the
location specified in the packet is equals to any of the value of the
branches of this node. 'SetBase' means set the base address as
specified by 'setbase action'. 'SetPrio' means set the internal
priority, which is used along with egress port traffic class mapping
table, to determine the output queue. 'Count' means count the
number of packet and bytes in the packets reaching this nodes.
'RetagPrio' means set the priority in the outgoing packet, which is
also used along with egress port traffic class mapping table, to
determine the output queue. 'MatchInGenList' means match value
in packet with values in genlist. For Leaf node, Drop, Fwd,
FwdToCtl, CpToCtl, Allow and GoToNextRule are valid actions.
For Unary node, Count, SetPrio and RetagPrio are valid actions.
For Binary node, Eq, Gt, Lt, SetBase and MatchInGenList are valid
actions. For Ternary node, TerCmp and InRange are valid actions.
For Linear node, only MatchInList is a valid action. For NonLinear
node, MatchinList and AccDeny are valid actions.
Type: Create -- Mandatory
Modify -- Optional
Default value: -----
Ntype
Leaf|Unary|Binary|Ternar
y|Linear|NonLinear
This specifies the type of the Classifier node.
Type: Create -- Mandatory
Modify -- Optional
Valid values: 1 - 0xffffffff
Default value: -----
Offsetval offsetval
OffSet, in the packet with respect to the base offset,
from where we have to take the value, which is to be matched. If
gsvClfrProfileNodeAction is SetBase and
gsvClfrProfileNodeSetBaseType is Compute then this value is
used to specify the offset with respect to the base offset, which
shall be used to specify the field of the packet used to compute the
new base offset. If the gsvClfrProfileNodeValType is U8 the offset
can be odd or even. If the
gsvClfrProfileNodeValType is U16, U32 or U64 then
the offset can only be even. This field is not valid for
any other value type.