Filter
Top Products
IDL series User Guide
206
floodsupport enable |
disable
This is used to specify whether the unknown unicast packets are to be
flooded or not. The value for this is used along with per vlan
configuration for flood support to determine if flooding has to be done
for unknown unicast packet.
Type : Optional
Valid Values: enable | disable
bcastsupport
enable|disable
This is used to specify whether the broadcasting is supported or not.
The value for this is used along with per vlan configuration broadcast
support, to determine if broadcasting has to be done for the broadcast
packet.
mcastsupport
enable|disable
Used to specify whether the multicast is supported or not.
Type : Optional
Valid Values: enable| disable
mcastdrop
enable|disable
Used to specify whether the multicast packets are to be dropped, or to
be forwarded, if multicast is not supported. This is only valid if
dot1dTpMcastSupport is false.
Type : Optional
Valid Values: enable|disable
dropiffdbfull enable |
disable
This specifies if the frame for which learning could not be done
because of forwarding table limit being reached, is to be dropped. If this
is enabled the frame for which learning could not be done because of
limit exceeded shall be dropped, else forwarded based on bridge
forwarding logic.This being enabled shall reduce flooding, as when a
response to such a frame from which learning could not be done shall
come the frame shall be flooded, as the entry for that unicast address,
shall not be found in forwarding table.
Type : Optional
Valid Values: enable or disable
Default value: enable
resnetlearning enable
| disable
This specifies if learning can be done over net side port for residential
bridging. Learning shall be done on Net port in case of vlan with
residential bridging if 'dot1dPortGsLearningStatus' and
'dot1dTpGsResidentialNetLearning'is enabled. In case of vlan with
'unrestricted' or 'restricted' bridging the learning is governed only by per
port configuration i.e. 'dot1dBasePortTable'. Currently the modification
of this parameter is not supported.
Type : Optional
Valid Values: enable or disable
Default value: enable
resvmacprofileid
The Profile is used to determine the behavior for Reserved Mac