Filter
Top Products
User’s Guide for the Polycom RealPresence Group Series and the Polycom Touch Control
Polycom, Inc. 3
Powering On and Off
Powering your system on and off is a simple procedure, but it is important to perform the tasks in a certain
order. Make sure that the system is powered off before you connect devices to it. After you have connected
all of the related equipment that you will use, connect the power and power on the RealPresence Group
system.
It is also important to note that Polycom RealPresence Group systemsdo not have what you might think of
as a power button—they have a power proximity sensor. Instead of pressing an actual button that moves,
you touch the sensor (or near the sensor) that indicates power on the front of the system.
To power on the RealPresence Group System:
Do one of the following:
● Press any button on the remote control or pick up the remote control to wake up the system if it is
asleep.
● Touch and hold the power sensor on the front of the system. Because the power sensor is touch
sensitive, you can touch your finger on or close to the sensor.
The Polycom splash screen is displayed within several seconds.
To power on the Polycom Touch Control:
» Reconnect the LAN cable to the underside of the device. The Home button is lit when the device is
powered on.
To power off the Polycom Touch Control:
1 From the Home screen, touch .
2 Scroll to Power.
3 Select Touch Control Power.
4 In the menu that appears, select Power Off the Touch Control. If you choose to power off the
Polycom Touch Control, you must disconnect and reconnect the LAN cable to power it on again.
To wake up the Polycom Touch Control:
» The Polycom Touch Control goes to sleep after 2 minutes of inactivity. Touch the screen to wake it up.
Pairing with a RealPresence Group System
Before you make a call using the Polycom Touch Control, you must pair the Touch Control with a
RealPresence Group system. After the devices are successfully paired, the connection persists until you
either disconnect or power off the RealPresence Group system.
To pair with a RealPresence Group system:
1 Do one of the following: