Filter
Top Products
Install The Ferrite
21
Figure 7. Adding the Grommet to the Power/Data Cable
11. On the media side of the printer, slide the grommet onto the
power/data cable and insert it into the hole in the frame wall.
(Figure 7.)
12. Inspect the power/data cable to ensure approximately
17 inches of cable is exposed from the grommet to connect it to
the validator.
NOTE: You will plug the power/data cable into the validator later.
Grommet
Power/Data Cable
(approximately
17 inches exposed)
InsertedGrommet
(Media Side)
Long
Connector