Filter
Top Products
Bad Bar Code Error Detection
61
Bar Code Failures
The validator tells the printer to announce a fault condition in two
situations:
• if the validator detects a bad bar code
• if the validator detects no bar code where it expects to find one.
How the printer reacts to these faults is determined by the printer’s
configuration settings, as described below.
Bad Bar Code Error Detection
The validator examines every bar code that passes under the
scanning beam and sends an analysis report to the printer. If a bar
code is reported to have failed to meet any of the acceptance
criteria, an error condition is reported. How the printer then reacts is
described in “Error Action” on page 62.
Missing Bar Code Error Detection
A bar code may print so poorly that the validator cannot detect it,
and the printer does not receive an analysis report for the code. To
catch this problem, the printer tracks the position of the last label
printed and knows when it should have completely passed the
scanning beam. It can then compare the number of bar code
analysis reports it expected to the number it received. If the printer
does not receive enough bar code reports, it enters an error
condition. How the printer then reacts is described in “Error Action”
on page 62.
The number of bar codes expected is determined one of two ways:
• If “Auto” is selected for the “Number of Codes” parameter, and
you are using LinePrinter Plus
®
,IGP
®
/PGL
®
,IGPCodeV™,or
IPDS™ graphics software, the printer compares the number of
bar code commands it receives from the software to the
number of analysis reports it receives from the validator.