Filter
Top Products
Chapter 1 Installation
24
Figure 10. Installing the Validator/Upper Bracket Unit onto the Lower Bracket
2. Face the front of the printer while installing the validator/upper
bracket unit.
3. Loosen the two adjustment screws on the bottom of the
validator.
4. Slide the validator/upper bracket unit onto the lower bracket and
align the hash marks accordingly. Refer to Figure 10, Detail A for
location of the validator hash mark for each printer model size.
NOTE: The printer model size is also inscribed on the lower
bracket.
5. When the unit is positioned correctly, tighten the two
adjustment screws on the validator to lock the unit into place.
A
A
4in.
6 in. 8 in.
Printer
Lower
Bracket
Hash
Marks
Adjustment
Screw (2)
Validator
(Front View)
Validator
(Rear View)
Upper
Bracket