Filter
Top Products
Attach The Power/Data Cable To The Validator
25
Attach The Power/Data Cable To The Validator
Figure 11. Attaching the Power/Data Cable
1. Loosen the three upper bracket screws and route the
power/data cable through the cable channel in the upper
bracket, as shown in Figure 11.
2. Plug the long connector end of the power/data cable into the
validator.
3. Route the power/data cable behind the bracket tab, as shown
in Figure 11.
NOTE: If necessary, loosen the bracket mounting screws enough
to slip the power/data cable behind the bracket tab, then
retighten the bracket mounting screws.
4. Pull the cable to minimize the slack behind the lower bracket.
Push any excess slack through the grommet.
5. Tighten the three upper bracket screws.
Power/Data Cable
(Long Connector)
Cable
Channel
Bracket Tab
Grommet
UpperBracket
Screw (3)
Bracket Mounting Screw (4)