Filter
Top Products
Chapter 2 Basic Validator Setup
40
• RESET: This button is used in the calibration procedure and
possible troubleshooting situations. Except in these specific
circumstances, the RESET button should not be used.
CAUTION
Do not lift the printer by the validator unit or by the lower
bracket.
CAUTION
The validator contains sensitive electronic equipment. Do not
jar or drop the unit.
Table 3. RESET Button Settings
Time RESET Button Is Depressed Result
Less than 2 seconds Turns on scanning beam
More than 4 but less than 6 seconds Validator goes into calibration mode
More than 6 seconds Resets validator to factory calibration and
turns off scanning beam