Filter
Top Products
Psion Teklogix NETBOOK PRO User Manual 97
Chapter 7: Configuring Communications
NETBOOK PRO Bluetooth Settings
7.3.1.1 Devices Menu Page
Scan
In the Devices menu page, click on the Scan button and wait for the NETBOOK
PRO to complete its scan (approximately 20 seconds). When scanning starts, the
‘Scan’ button will change to ‘Stop’, and if needed you can click on this button to
stop the process. Once scanning is complete, all discovered devices will be dis-
played in the list box, with Name, Address, Active status, and PIN information.
If the discovered device has been given a unique Name by its owner, that name is
used to identify it along with its Bluetooth Address. To see the Address of the Blue-
tooth radio in your NETBOOK PRO, click on the Property tab of the Bluetooth
Controls menu (see “Property Menu Page” on page 101).
Note: During scanning, addresses are scanned for first, and then the names.
Therefore, for remote devices that are not in good Bluetooth radio cover-
age, the scanning process may complete without retrieving all the names.
The Active column indicates whether any service is activated for that device. When
a service is activated, the device will show up on the list even when it is not detected
during the scan.
The PIN column indicates whether you have a PIN (password) set for the device.
At this point you can either query for services or set the PIN for each device.
Once you highlight a device in the list box, both the Services and Set PIN buttons
become available.