Q-Logic 59047-10 D Switch User Manual


  Open as PDF
of 264
 
2–Configuring a Switch
Configuring a Switch Using the Command Line Interface
2-2 59047-10 D
Configuring a Switch Using the Command Line
Interface
The Telnet command line interface offers a convenient way to change SNMP
parameters. SNMP parameter defaults are preset during manufacturing. For
security purposes, these default values should be changed. For specific
information about SNMP parameters, refer to the SNMP Configuration section in
the corresponding QLogic Switch Management User Guide. To configure a switch
using the command line interface, do the following.
 previous next