Filter
Top Products
3–MIB-II Objects
ifSpeed (1.3.6.1.2.1.2.2.1.5)
59047-10 D 3-7
ifSpeed (1.3.6.1.2.1.2.2.1.5)
An estimate of the interface's current bandwidth in bits per second. For interfaces
that do not vary in bandwidth or for those where no accurate estimation can be
made, this object should contain the nominal bandwidth. If the bandwidth of the
interface is greater than the maximum value reportable by this object, then this
object reports its maximum value (4,294,967,295) and ifHighSpeed must be used
to report the interface's speed.
Syntax Gauge
Access read-only
Status mandatory
ifPhysAddress (1.3.6.1.2.1.2.2.1.6)
The interface's address at the protocol layer immediately “below” the network
layer in the protocol stack. For interfaces that do not have such an address, such
as a serial line, this object should contain an octet string of zero length.
Syntax PhysAddress
Access read-only
Status mandatory
ifAdminStatus (1.3.6.1.2.1.2.2.1.7)
The desired state of the interface. The testing(3) state indicates that no
operational packets can be passed.
Syntax INTEGER
Access read-only
Status mandatory
Return Value Writes not supported.