Filter
Top Products
Appendix A: Informational Notes
202
Changing a USB Profile when Using a Smart Card Reader
There may be certain circumstances under which you will need to
change the USB profile for a target server. For example, you may need
to change the connection speed to "Use Full Speed for Virtual Media
CIM" when the target has problems with the "High Speed USB"
connection speed.
When a profile is changed, you may receive a New Hardware Detected
message and be required to log in to the target with administrative
privileges to reinstall the USB driver. This is only likely to occur the first
few times the target sees the new settings for the USB device. Afterward,
the target will select the driver correctly.
Note: This feature is available with the KX II 2.4.0 (and later).
Virtual Media
Virtual Media Not Refreshed After Files Added
After a virtual media drive has been mounted, if you add a file(s) to that
drive, those files may not be immediately visible on the target server.
Disconnect and then reconnect the virtual media connection.