Renesas M30850T-EPB Switch User Manual


 
( 50 / 76 )
4.2 Downloading Firmware
(1) When It is Necessary to Download Firmware
It is necessary to download the firmware when:
(1) you use this product for the first time
(2) the firmware has been upgraded
(3) the emulator debugger has been upgraded
(4) you use this product with a PC7501 which was used with other emulation probe before
When you use this product for the first time or when the power is unexpectedly shut down during
firmware download, redownload the firmware in maintenance mode.
(2) Downloading Firmware in Maintenance Mode
Download the firmware in maintenance mode as explained here following. The target system must
not be connected when downloading the firmware.
(1) Set the interface select switch on the rear panel of the PC7501 to the LPT side and connect
the LPT parallel interface cable to the PC7501 and the host machine.
(2) Within 2 seconds of activating power to the emulator, press the RESET switch on the PC7501
upper panel to switch to maintenance mode.
Switched to maintenance mode, the SAFE SYSTEM STATUS LED begins to flash.
(3) Start up the emulator debugger. When the Init dialog box setup is complete, the dialog which
urges to download the firmware will appear. Download the firmware following messages.
Required time for downloading the firmware is about 60 seconds.
Figure 4.2 Downloading firmware in maintenance mode
CAUTION
Note on Downloading Firmware:
Do not shut OFF power while the firmware is being downloaded. Doing so, the
emulator will not start up properly. If power is shut OFF by mistake, redownload the
firmware in maintenance mode.
POWER
CLOCK
RUN
RESET
WARNING
TARGET
STATUS
SYSTEM
STATUS
POWER
SAFE
ERROR
POWER
CLOCK
RUN
RESET
WARNING
TARGET
STATUS
SYSTEM
STATUS
POWER
SAFE
ERROR
POWER
CLOCK
RUN
RESET
WARNING
TARGET
STATUS
SYSTEM
STATUS
POWER
SAFE
ERROR
POWER
CLOCK
RUN
RESET
WARNING
TARGET
STATUS
SYSTEM
STATUS
POWER
SAFE
ERROR
POWER
CLOCK
RUN
RESET
WARNING
TARGET
STATUS
SYSTEM
STATUS
POWER
SAFE
ERROR
Maintenance mode started Downloading firmware started
Download terminated
: ON
: OFF
: Flashing