Filter
Top Products
Fax Maintenance
Tone Signal Settings
Tone Signal
Transmission Time
Length
Sets the tone signal transmission time length
[100 ms (Default)]
Minimum Pause In
Tone Dialing
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Attenuator For
Pseudo Ring
Backtone To
the Line
Sets the attenuator for pseudo ringback tone to the line
[0 to 15 / 10 (Default)/ 1 dB/step]
DTMF Level
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]
DTMF Delta
Sets the level difference between high band frequency
signals and low band frequency signals when sending
DTMF tones.
[2 dBu/ 3 dBu]
1Dial Tone Detection
Wait Time
The machine starts dialing after the specified interval
without detection of a dial tone when
Dial tone detection is set to "No detection".
[3.5 Sec (Default)/ 7.0 Sec/ 10.5 Sec
/ 14.0 Sec]
Timeout Length
This setting sets the time-out length for the 1st dial tone
detection. The machine waits for a dial tone for the
specified time and disconnects itself from the line when
no dial tone is input.
[10 Sec (Default)/ 15 Sec/ 20 Sec/ 30 Sec]
Service Program Mode
101
5